CQ-18T

Switching the Enabled Network on a CQ-20B The enabled network can be switched between Ethernet and WiFi Access Point from the CONFIG / CONTROL & NETWORK / Network screen in CQ-MixPad. The enabled network can also be switched at any time on the unit itself with a short press of the RESET button. The Chromatic Meter (CM) LED will then flash briefly to show the enabled network.

flashing BLUE ⚫

= Wi-Fi enabled

•

• flashing YELLOW ⚫ = Ethernet enabled If there are problems connecting, carry out a network or full reset of the unit.

Connect using WiFi Access Point (CQ-18T, CQ-20B) 1) Navigate to CONFIG / CONTROL & NETWORK / Network

 If there is already a connection to the CQ-20B, otherwise follow First connection to a CQ-20B. 2) Switch Enabled Network to WiFi Access Point 3) Set the WPA2 Password. 4) Setup the network. Recommended settings are: • WPA2 Password on • Frequency dependent on environment and other equipment  If using Bluetooth which works across 2.4GHz, setting Wi-Fi to use 5GHz can prevent interference issues. • SSID Hidden (once all devices have connected and stored network details) 5) Note the network name (SSID) and password. 6) Apply any changes. 7) Connect the remote device to the Wi-Fi network that’s just been set up. 8) Run CQ-MixPad or CQ4You and connect to the CQ from the Choose Unit list.  If the unit does not appear in the choose unit list, try selecting ‘Other’ and entering the IP address manually. The current IP address of the unit is listed in the HOME / SYSTEM / Info screen. • Channel set to Auto

 19

User Guide V1.2 Issue 5