CQ-18T

Send signal from Inputs to Outputs 1-6 Prior to sending signal anywhere, preamp gain or trim should be set correctly for the input source. Follow the How to Use Gain Assistant section for best results. This ensures optimum signal level coming into the channel for processing, but more importantly when thinking about sending (routing) signals, changing the preamp gain or trim also affects the level of signal being sent to any outputs.  Sends from Inputs to each Out can be set ‘Pre or Post Fade r ’ in the CONFIG / OUTPUTS screen. Post Fader means the channel send level to the output depends on both the set send level to the output and the send level to Main LR. Pre Fader sends on the other hand, are completely independent and mostly used for monitoring.  Sends to Outputs 1-6 are sourced Post-PEQ (Pre-Comp) from input channels. This means that the full dynamic range is heard by performers in monitors, and that the compressor on each input affects only the Main LR.

Send one input at a time using the PROCESSING screen

Go to PROCESSING / INPUTS and select the channel to be sent.

1.

2. Touch/Click the SENDS section at the bottom of the channel strip to display and adjust all send levels for that channel.

3. Use the blue faders to adjust the send levels from

Repeat steps 1 and 2 for other inputs as required.

 43

User Guide V1.2 Issue 5