CQ-18T

Using an FX Unit in Inserted Mode

Go to the FX screen and select one of the FX Units on the left-hand side.

1.

To choose a different FX type, use the Library button at the right top corner of the screen, select an FX type or stored preset then recall it.

2.

At the top of the screen, ensure the CONTROL tab is selected and the FX Unit controls are shown.

3.

Toward the bottom left, set FX Unit Mode to Inserted (if not already set) and select a channel to insert the FX Unit into from the pop-up.

4.

To change the channel the FX Unit is inserted into at any time, touch/click the Insert ( channel ) button. Adjust FX parameters. (Refer to the FX section of this guide for a detailed description and configuration of each FX).

5.

6.

Use the Mix control to adjust the balance of signal between 0% (only direct/’dry’ signal, no FX heard) and 100% (only FX/’wet’ signal, no direct/’dry’ signal heard).

7.

Switch the inserted FX Unit in and out of the channel instantly using the In/Out button.

8.

 Inserted FX Units are shown with an icon in the channel strip on the PROCESSING screen. Selecting this will jump to the FX Unit in the FX screen.

 52

User Guide V1.2 Issue 5