MaestroDMX

Hardware Connectivity MaestroDMX is a plug-and-play autonomous lighting controller that can be set up and functioning within minutes.

Connector Interface

1. Power connector

5V USB-C power port. 2 A max input current. Provides power to the MaestroDMX and attached USB devices.

NOTE: if you power MaestroDMX on the same device as your audio output e.g. a laptop, it can cause a “ground loop” that will introduce noise and affect the performance of the system. You can avoid this by powering MaestroDMX from a different device or power source or by using an inline ground loop isolator. Two USB-A ports are available for a Wi-Fi dongle, MIDI, an external audio interface, and software updates via a USB flash drive. NOTE: Do not use the USB-A ports for anything other than the above-mentioned uses.

2. USB 2.0 Type A connectors (500mA max per port)

3. Ethernet connector

The ethernet connector provides a hardwire connection from your computer/tablet to the MaestroDMX. An alternative to connecting over Wi-Fi.

4. Line in / RCA audio connector

The Audio connector allows MaestroDMX to receive audio from your source. MaestroDMX expects a stereo consumer line-level input signal (-10dBV max).

5. DMXOUT

DMX OUT connects your fixtures via a DMX cable directly to the MaestroDMX (1x Universe, 512 channels).

6. Indicator Light