RCF RDNet Control 2

RDNet 4.0 User Manual Rev. A

4.1

CONTROL 2 / CONTROL 8 SETUP

Link a CONTROL 2 to a computer via USB single controller and it is automatically detected by the software (without any type of configuration).

Link a CONTROL 8 to a computer via USB single controller and it is automatically detected by the software (without any type of configuration). As soon as a controller is connected, RDNet will automatically check for the firmware status. Is the firmware being not up to date, the software will indicate the need to update it.

CONTROL 8 also has an Ethernet port that can be used to connect a computer (TCP/IP protocol). In this case, up to 20 CONTROL 8 can be linked to a single computer through dedicated Ethernet switches. To use CONTROL 8 via Ethernet, proceed as follows: Link the CONTROL 8 unit to the computer via USB. Restart RDNet and click button.

It is now possible to see the label that shows Control 8 connected via USB and its Name .

Click on button or select on the toolbar menu.

14