RCF RDNet Control 2

RDNet 4.0 User Manual Rev. A

10.3

SPECIAL FUNCTIONS

From the '< Advanced> ' toolbar menu, it is possible to enable the following special functions:

DISPLAY SETUP

Some speaker models have an LED display for their parameter editing. In situations of use in low-light environments, the light emitted by displays may interfere with the show. Select < Advanced > allows you to turn on / off all RDNet device displays.

RESET PASSWORD

Select this function to reset / delete the password. After toggling from < Concert > to mode, a new password will be required . This precaution allows the sound engineer (only) to toggle to mode and edit parameters.

RESET DEVICES

performs a device reboot without switching it off. When rebooting, all linked downstream devices are disconnected. It is necessary to select first < Offline> ' then < Online > (again) to restore control and connections of all devices.

< Set Default Values > restores factory settings to the device.

RESET ANGLE

Most devices have an internal inclinometer. The device tilt (' Angle ') can be read in its extended attributes. This value is important when using two engines to suspend a line array.

Select the devices where the inclinometer must be reset and click on < Reset Angle> .

To reset it properly: place the device on a perfectly flat ground and then click ' Reset Angle on selection '.

This procedure is periodically needed, due to possible shocks experienced by devices during their transport and assembly.

71