RCF RDNet Control 2

RDNet 4.0 User Manual Rev. A

12.8

DMA 162P OUTPUTS

1. STEREO / BRIDGE (/ MONO) MODE SELECTION

To activate the stereo mode, click the STEREO button (it lights up). Click it again to turn it off. To activate the bridge mode (single 70 V line output), click the BRIDGE button (it lights up). Click it again to turn it off. When either the stereo or the bridge mode is selected, OUT B controls are disabled and its GAIN is linked to the OUT A GAIN level. The two buttons STEREO and BRIDGE are mutually exclusive: when turning one on, the other automatically turns off. For the MONO mode (two separate and independent outputs), leave both set to OFF.

2. GAIN Gain level adjustment of its respective output.

3. MUTE Click the MUTE button to mute its respective output.

Click it again to unmute.

4.

BASS ENHANCER Click the BASS ENHANCER button to enable the bass enhancer on its respective output. Click it again to disable it. POLARITY Click the POLARITY button to invert the signal polarity of its respective output. Click it again to disable it and restore normal polarity. PEQ (2-BAND PARAMETRIC EQUALIZER) Click it to open the 2-band parametric equalizer window of its respective output. See the manual section 12.5 2-BAND PARAMETRIC EQUALIZER . HI-PASS FILTER Click on the up/down arrows to increase/decrease the hi-pass filter cutoff frequency (note: it is also possible to directly insert its value by using the computer numeric keyboard after clicking the number) of its respective output. SPEAKER PRESET Click it to open a drop-down menu to selects the speaker preset (suitable for the used speakers) of its respective output. The default ALL FLAT option: no equalization applied.

5.

6.

7.

8.

9.

Vu meter LED bar indicating the current signal level of its respective output.

10. SUB/OUT

87